Raw Materials for mobile accessories brands in Delhi NCR

Common passives on reels or in kits for PCB assembly and prototypes.

Click button for power, volume and reset on almost every gadget.

Protects mains appliances and adapters from overload and short circuit.

USB Type-C socket for charging and data on power banks, earbuds cases and gadgets.

Small plug-and-socket connectors for batteries, speakers and displays inside a product.

Small board that stops over-charge, over-discharge and short circuit. USB-C charging option.

Soft tinned-copper wire for battery packs, heaters, motors and internal wiring.

Shrinks over joints and cells with a heat gun for insulation and a neat finish.

Small self-tapping and machine screws for plastic housings and PCBs.

Self-stick feet for speakers, chargers, keyboards and appliances. Stops sliding.

Linear charger chip that charges a 3.7 V cell safely from USB. Used in almost every gadget.

Cylindrical 3.7 V cells for power banks, speakers, trimmers and torches. Capacity-tested lots.

Chip-on-board LED for spotlights, downlights, torches and ring lights.

Sharp, low-power OLED for wearables, smart devices, power banks and gadgets.

Ready plastic box for gadgets, chargers, sensors and control boards. Cut-outs on request.

Metal threads for plastic housings so screws can be opened and closed many times.

Strong N35–N52 magnets for magnetic chargers, cases, closures and speaker parts.

Extruded or stamped heatsinks for LED boards, chargers, amplifiers and SSDs.

Fast-charge protocol chip for USB-C chargers, power banks and car chargers.

General-purpose chip that runs your product firmware. Good for appliances and gadgets.

Bigger 3.7 V cells for high-power blenders, hair dryers, fans and large power banks.

Flat 3.7 V cells for slim power banks, speakers, wireless mice and LED lamps.

Plain charge + data cables ready for your packaging. E-marker option for 100 W.

Everyday charging cable to pack with earbuds, trimmers, speakers and power banks.

Fast-charge cable for phones with the 8-pin port. Generic, not officially certified.

Long-life, safer cells for portable power stations, solar lights and backup units.

Cells spot-welded with BMS, thermistor, wires and connector, shrink-wrapped to your size.

Steel stencil made from your PCB files for printing solder paste before SMT assembly.

A small lot of boards to test your design before mass production. Up to 100 × 100 mm.

Low-cost boards for chargers, LED drivers and simple circuits. Price per board up to 100 × 100 mm.

Ready charge-discharge board for power banks. Add cells and a case to finish.

Standard 2-layer boards for most gadgets. Price per board up to 100 × 100 mm.

12–24 V car socket charger with fast charging on both ports.

Coil + board to build wireless charging pads, stands and 3-in-1 docks.

Dense boards for Wi-Fi, Bluetooth and MCU products. Price depends on size and layer count.

Fast phone charger with your logo. BIS registration is needed in your brand name.

Brushless motor for table fans, hair dryers, air purifiers and handheld fans.

Bendable circuits for smartwatches, earbuds and hinged products. Made to your drawing.

Small, cool-running charger for laptops, tablets and phones at the same time.