Raw Materials for audio & earbuds brands in India

Steel stencil made from your PCB files for printing solder paste before SMT assembly.

Common passives on reels or in kits for PCB assembly and prototypes.

Click button for power, volume and reset on almost every gadget.

On/off slide switch for toys, torches, trimmers and battery gadgets.

Small self-tapping and machine screws for plastic housings and PCBs.

Self-stick feet for speakers, chargers, keyboards and appliances. Stops sliding.

USB Type-C socket for charging and data on power banks, earbuds cases and gadgets.

Small plug-and-socket connectors for batteries, speakers and displays inside a product.

Small board that stops over-charge, over-discharge and short circuit. USB-C charging option.

A small lot of boards to test your design before mass production. Up to 100 × 100 mm.

Soft tinned-copper wire for battery packs, heaters, motors and internal wiring.

Shrinks over joints and cells with a heat gun for insulation and a neat finish.

Strong N35–N52 magnets for magnetic chargers, cases, closures and speaker parts.

Extruded or stamped heatsinks for LED boards, chargers, amplifiers and SSDs.

Linear charger chip that charges a 3.7 V cell safely from USB. Used in almost every gadget.

Cylindrical 3.7 V cells for power banks, speakers, trimmers and torches. Capacity-tested lots.

Battery management board for 7.4–14.8 V packs in blenders, speakers, lamps and tools.

Low-cost boards for chargers, LED drivers and simple circuits. Price per board up to 100 × 100 mm.

Small round speaker for Bluetooth speakers, toys, smart plugs and voice prompts.

Low-cost mic capsule for earphones, neckbands, doorbells and voice remotes.

Low-cost charging cable for toys, torches, speakers and older gadgets.

Standard 2-layer boards for most gadgets. Price per board up to 100 × 100 mm.

Wall adapter for LED strips, routers, cameras, speakers and small appliances.

Basic USB charger to bundle with trimmers, speakers, lamps and toys.

Replacement ear tips for earbuds and IEMs, sold in S/M/L sets.

Ready module for speakers, neckbands and soundbars. Plays music and handles calls.

Coin-cell friendly module for trackers, wearables, wireless mice and remotes.

General-purpose chip that runs your product firmware. Good for appliances and gadgets.

Bigger 3.7 V cells for high-power blenders, hair dryers, fans and large power banks.

Thin 3.7 V pouch cells with leads for earbuds, smartwatches, trackers and small toys.

Flat 3.7 V cells for slim power banks, speakers, wireless mice and LED lamps.

Small dynamic speaker driver for TWS earbuds, neckbands and wired earphones.

Full-range woofer driver with rubber surround for portable and party speakers.

Plain charge + data cables ready for your packaging. E-marker option for 100 W.

Everyday charging cable to pack with earbuds, trimmers, speakers and power banks.

Mains cord with moulded Indian 2-pin plug for appliances, chargers and lamps.

Dense boards for Wi-Fi, Bluetooth and MCU products. Price depends on size and layer count.

Bendable circuits for smartwatches, earbuds and hinged products. Made to your drawing.

Unpowered bass membrane that adds low end to compact Bluetooth speakers. Made to your size.

Cells spot-welded with BMS, thermistor, wires and connector, shrink-wrapped to your size.