Raw Materials for smartwatches & wearables brands in India

Steel stencil made from your PCB files for printing solder paste before SMT assembly.

Common passives on reels or in kits for PCB assembly and prototypes.

Click button for power, volume and reset on almost every gadget.

Small self-tapping and machine screws for plastic housings and PCBs.

USB Type-C socket for charging and data on power banks, earbuds cases and gadgets.

Small plug-and-socket connectors for batteries, speakers and displays inside a product.

Small board that stops over-charge, over-discharge and short circuit. USB-C charging option.

A small lot of boards to test your design before mass production. Up to 100 × 100 mm.

Soft tinned-copper wire for battery packs, heaters, motors and internal wiring.

Shrinks over joints and cells with a heat gun for insulation and a neat finish.

Sharp, low-power OLED for wearables, smart devices, power banks and gadgets.

Strong N35–N52 magnets for magnetic chargers, cases, closures and speaker parts.

Linear charger chip that charges a 3.7 V cell safely from USB. Used in almost every gadget.

Digital sensor for smart thermostats, air purifiers, weather displays and kitchen gadgets.

Flat 8–12 mm vibration motor for smartwatches, massagers, game controllers and toys.

Low-cost boards for chargers, LED drivers and simple circuits. Price per board up to 100 × 100 mm.

Low-cost mic capsule for earphones, neckbands, doorbells and voice remotes.

Standard 2-layer boards for most gadgets. Price per board up to 100 × 100 mm.

Replacement ear tips for earbuds and IEMs, sold in S/M/L sets.

Coin-cell friendly module for trackers, wearables, wireless mice and remotes.

General-purpose chip that runs your product firmware. Good for appliances and gadgets.

Counts steps, detects wrist raise and tilt. For watches, bands, game controllers and toys.

Thin 3.7 V pouch cells with leads for earbuds, smartwatches, trackers and small toys.

Small dynamic speaker driver for TWS earbuds, neckbands and wired earphones.

Plain charge + data cables ready for your packaging. E-marker option for 100 W.

Coil + board to build wireless charging pads, stands and 3-in-1 docks.

Green/red LED optical sensor for pulse and blood oxygen readings in watches and bands.

Dense boards for Wi-Fi, Bluetooth and MCU products. Price depends on size and layer count.

Bendable circuits for smartwatches, earbuds and hinged products. Made to your drawing.