Raw Materials for grooming appliances brands in Mumbai

Common passives on reels or in kits for PCB assembly and prototypes.

Click button for power, volume and reset on almost every gadget.

On/off slide switch for toys, torches, trimmers and battery gadgets.

Protects mains appliances and adapters from overload and short circuit.

USB Type-C socket for charging and data on power banks, earbuds cases and gadgets.

Plastic holders with wires or pins for AA, AAA and coin cells. With or without switch.

Beeper for kettles, trimmers, alarms and toys. Active (built-in driver) or passive.

Linear charger chip that charges a 3.7 V cell safely from USB. Used in almost every gadget.

Small board that stops over-charge, over-discharge and short circuit. USB-C charging option.

Flat 8–12 mm vibration motor for smartwatches, massagers, game controllers and toys.

Snap-disc thermostat that cuts power when hot. For irons, kettles, dryers and heaters.

Tiny metal gearbox motor for smart locks, curtain openers, toys and robots.

Cylindrical 3.7 V cells for power banks, speakers, trimmers and torches. Capacity-tested lots.

Battery management board for 7.4–14.8 V packs in blenders, speakers, lamps and tools.

General-purpose chip that runs your product firmware. Good for appliances and gadgets.

Bigger 3.7 V cells for high-power blenders, hair dryers, fans and large power banks.

Brushless motor for table fans, hair dryers, air purifiers and handheld fans.

Heating wire and mica-wound elements for hair dryers, straighteners and air fryers.

Cells spot-welded with BMS, thermistor, wires and connector, shrink-wrapped to your size.

Small self-tapping and machine screws for plastic housings and PCBs.

Steel stencil made from your PCB files for printing solder paste before SMT assembly.

Soft tinned-copper wire for battery packs, heaters, motors and internal wiring.

Shrinks over joints and cells with a heat gun for insulation and a neat finish.

A small lot of boards to test your design before mass production. Up to 100 × 100 mm.

Low-cost charging cable for toys, torches, speakers and older gadgets.

Low-cost boards for chargers, LED drivers and simple circuits. Price per board up to 100 × 100 mm.

Standard 2-layer boards for most gadgets. Price per board up to 100 × 100 mm.

Everyday charging cable to pack with earbuds, trimmers, speakers and power banks.

Mains cord with moulded Indian 2-pin plug for appliances, chargers and lamps.

Basic USB charger to bundle with trimmers, speakers, lamps and toys.

Bare mains-to-DC power board that fits inside appliances, smart switches and lamps.

Moulded silicone buttons for remotes, appliances and toys. Printed icons, carbon contacts.